![background image](http://html1.mh-extra.com/html/napoleon/legend-ld3/legend-ld3_manual_3638452016.webp)
16
EN
www.napoleon.com
N415-0560 JUL06.21
Problem
Possible Causes
Solution
Burners will not cross
light each other.
Dirty or corroded cross light brackets.
Clean or replace as required.
“Paint” appears to be
peeling inside lid or
hood.
Grease build-up on inside surfaces.
This is not a defect. The finish on the lid and
hood is porcelain, and will not peel. The peeling
is caused by hardened grease, which dries into
paint-like shards, that flake off. Regular cleaning
will prevent this. See cleaning instructions.
Burner output on
“high” setting is
too low. (Rumbling
noise and fluttering
blue flame at burner
surface.)
Lack of gas.
Supply hose is pinched.
Dirty or clogged orifice.
Spider webs or other matter in venturi tube.
Propane regulator in “low flow” state.
Check gas level in propane cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.
Ensure lighting procedure is followed carefully.
All gas grill valves must be in the off position
when the tank valve is turned on. Turn tank on
slowly to allow pressure to equalize. See lighting
instructions.
Infrared burner (if
equipped) flashes
back (during
operation the burner
abruptly makes
a loud “whoosh”
sound, followed by a
continuous blow-torch
type sound and grows
dim.)
Ceramic tiles overloaded with grease
drippings and build-up. Ports are clogged.
Burner overheated due to inadequate
ventilation (too much grill surface covered
by griddle or pan.)
Cracked ceramic tile.
Leaking gasket surrounding the ceramic tile,
or a weld failure in the burner housing.
Turn burner off and allow to cool for at least two
minutes. Relight burner and burn on high for at
least five minutes or until the ceramic tiles are
evenly glowing red.
Ensure that no more than 75% of the grill surface
is covered by objects or accessories. Turn burner
off and allow to cool for at least two minutes, then
relight.
Allow burner to cool and inspect very closely
for cracks. If any cracks are found, contact
your authorized Napoleon dealer to order a
replacement burner assembly.
Contact your authorized Napoleon dealer for
instructions on ordering a replacement burner
assembly.
Summary of Contents for LEGEND LD3
Page 18: ...18 EN www napoleon com N415 0560 JUL06 21 ...
Page 47: ...47 www napoleon com N415 0560 JUL06 21 ...
Page 48: ...N415 0560 ...