W415-1501 / E / 12.17.18
EN
26
fi nishing
7.4
door handle installation
Flat side of
“D” shape
Flat
Washers
Nut
Handle Spacer
Handle
Door
Rod
Bushing
Flat side of
“D” shape
Handle shaft
Latch
Flat Washers
Nut
Flat side
of “D”
shape
Handle
Spacer
Handle
Lock
Washer
Handle
Shaft
7.5 door
installation
note:
You may need to move washers to the other side of
the latch to obtain suffi cient door seal.
note:
The fi nal angle of the left door handle should mirror
the right door handle in the closed position. Tighten
the nut to secure the left handle at the desired angle.
A.
Insert the door rod through the round hole
of the latch, ensuring the fl at edge of the
D-shaped hole points towards the hinges.
B.
Slide the end of the door rod through the
bushing at the top of the door, as shown.
C.
Insert the handle shaft through the door and
latch.
D.
Secure with 2 fl at washers and a nut.
E.
Feed the handle through the handle spacer
and into the handle shaft.
A.
Insert the handle shaft through the door.
B.
Secure with a lock washer, 2 fl at washers, and
a nut.
C.
Feed the handle through the handle spacer
and into the handle shaft.
RIGHT DOOR HANDLE (OPERATING)
LEFT DOOR HANDLE (FIXED)
A.
Place brass washers onto the faceplate hinge bushing.
B.
Slide the door hinge pin into the faceplate hinge bushing.
C.
To remove the doors, open them slightly and lift them out
of the faceplate hinge bushings.
note:
2 extra washers are supplied in order to level the doors if
needed.