W415-1739 / C / 08.03.17
EN
10
Dynamic Heat Control™ installation
IMPORTANT:
It is recommended to install venting and vent heat shield(s) before refitting the
front, (and where applicable rear), frame for ease of access. It is critical for see-thru
appliances that ALL 4 knockout plates, ALL 4 cover plates are removed and ALL 4
deflectors are installed.
5.) Remove outer knockout fasteners.
Do not discard
fasteners.
6.) Secure deflectors to the appliance with fasteners removed in
step 5 and supplied fasteners.
5.) Secure deflectors to the appliance with supplied fasteners as
shown.
FOR LV38-1 / LV62
FOR LV50-2 / LV74
6.) Re-install front frame using the fasteners removed in step 1.
7.) Re-install front frame using the fasteners previously used
in step 1.
4.) Bend the sides of the deflectors as shown.
a
b
!
WARNING
• FOR SEE-THRU APPLIANCES, REPEAT STEPS WITH THE FIXED SIDE.
