W415-1767 / B / 11.23.17
EN
18
finishing
4.3 media installation
4.3.1 log set and topaz glass installation
A.
Remove the fasteners from the log set assembly.
B.
Remove log set assembly.
C.
Install media tray using previously removed fasteners from the
log set assembly and secure with additional supplied fasteners (4
screws for front media tray and 1 screw for back media tray).
D.
Carefully place acrylic crystals into the media tray, creating an even
layer from side to side.
E.
Repeat steps on the opposite side.
A.
Carefully place the topaz glass between the log set assembly (front and back side).
A.
Ensure to remove all acrylic crystals from the ember bed.
B.
Remove fasteners from the media tray (FIG. 1).
C.
Remove media tray (FIG. 2).
D.
Install log set assembly (FIG. 3).
E.
Carefully place the topaz glass between the log set assembly.
F.
Repeat steps on the opposite side.
Install the acrylic crystal media after framing the appliance and before installing the front glass.
Install the log set and topaz glass after framing the appliance and before installing the front glass.
If acrylic crystal media is installed:
If log set assembly is installed:
There are 2 media options for this appliance: log set and acrylic crystals. The log set assembly comes pre-installed
with the appliance and has to be finished with topaz glass. Refer to “log set and topaz glass installation” section. If
desired, this can be switched out with acrylic crystals. Refer to “acrylic crystal media installation” section.
Ensure to vacuum up any topaz glass or acrylic crystals outside the media tray area before operation.
Do NOT cover triangular covers on the back side of the unit. Blocking the triangular covers with media will alter
the flame appearance.
note:
Do NOT cover triangular covers on the back side of the unit. Blocking the triangular covers with media will alter
the flame appearance.
note:
FIG. 1
FIG. 2
FIG. 3
4.3.2 acrylic crystal media installation
#12 x 5