2. BIM605 BUILT-IN INSTRUCTIONS
This grill is designed for
MASONRY, NON-COMBUSTIBLE
enclosures only, and must be installed and serviced by a qualified installer
to local codes.
1. Attach side mounting brackets and side trim pieces to each side of the grill using 1/4-20 x 3/8" screws (n570-0073).
2. Fit heat shield into drip pan as illustrated.
3. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each wing of the
rear trim.
4. Lower the unit in place, and connect the gas supply line to the fitting at the end of the manifold.
5.The entire installation must be leak tested before operating the unit.
N715-0085
N080-0216
N570-0073
N080-0216
N710-0055
N585-0045
INSTALL BATTERY’S AS ILLUSTRATED. PLUG WIRE FROM LED
(LIGHTS) LOCATED UNDERNEATH CONTROL PANEL INTO WIRE FROM
BATTERY PACK. ENSURE WIRES DO NOT COME IN CONTACT WITH
THE BOTTOM OF THE GRILL.
THE BATTERY PACK MODULE (LED LIGHTS) MUST BE MOUNTED
INSIDE THE ENCLOSURE, AT LEAST 20cm BELOW THE BOTTOM OF
THE DRIPPAN, TO PREVENT THE MODULE FROM OVERHEATING.
ENSURE WIRES AND MODULE DO NOT INTERFERE WITH DRIPPAN
REMOVAL.
N010-0544-30(LP)
N475-0243
