EN
W415-1699 / 02.08.17
17
fi nishing
3.0 fi nishing
3.1
front glass installation
FOR MODELS NEFL50/60/72/100FH-EU ONLY:
A.
Before installing the front glass, remove the screws securing the paper board on the inside of the
appliance that protects the control panel. Discard the paper board.
B.
Reinstall the screws,see Figure 1. (For recessed installed appliances only)
C.
Remove the 2 screws from the top of the appliance.
D.
Have two people, lift the glass up and away from the appliance, holding the glass vertical not fl at while
carrying. Place the glass face down onto a soft, non-abrasive surface, careful not to fl ex the glass.
E.
Bend the top tabs fl at, see Figure 2
F.
Install the crystal embers, refer to "CRYSTAL EMBER INSTALLATION" section.
G.
Install the front glass by aligning with the pins on the appliance. Press the glass in and down to securely
engage with the brackets. It must be fully engaged to ensure the touch display panel performs properly.
H.
Secure the front glass using the screws provided to the top of the appliance, see Figure 3.(If fully recessed
this is not necessary)
Paper
Paper
Pin
FIG. 1
FIG. 2
•
Power supply service must be completed prior to fi nishing to avoid reconstruction.
•
Heat vents and air openings cannot be covered in any circumstances.
!
WARNING
!
WARNING
•
Glass may be hot. Do not touch glass until cooled.
•
If equipped with door latches that are part of a safety system, they must be properly engaged. Do not
operate the appliance with latches disengaged.
•
Facing and/or fi nishing materials must not interfere with air fl ow through air openings, louvre openings,
operation of louvres, or doors/access for service. Observe all clearances when applying combustible
materials.
•
Before door is removed, turn the appliance off and wait until appliance is cool to touch. Doors are heavy and
fragile so handle with care.
