CAUTION
• Do not use candles, matches or open flames of any kind in or
near the tent
• Do not cook inside the tent
• Build campfires downwind and several meters away from the
tent. Be sure to fully extinguish fires before leaving a campsite
or before retiring for the night
• Exercise extreme caution when using fuel-powered lanterns or
heaters inside or around the tent. Use battery-operated
lanterns whenever possible
• Do not refuel lamps, heaters or stoves inside the tent
• Extinguish or turn off all lanterns before going to sleep
• Do not smoke inside the tent
• Do not store flammable liquids inside a tent
• NEVER run the vehicle engine when the tent is attached
• Do not install the tent when the temperature is below
0ºC/32ºF or when your vehicle is wet, it may cause damage
• Allow adequate ventilation inside the tent at all times
• Do not attempt to drive the vehicle with the tent attached
CAMPSITE SELECTION
• Select a smooth level campsite clear of rocks, branches and
other hard or sharp objects
• Park the vehicle in the chosen campsite. Turn off the engine
and apply the parking brake
TENT SETUP
For easier assembly
, set the tent up on the ground leaving step
2 - 4 until the end. Once the poles are inserted, lift the tent into
the truck bed and strap down.
1. Lower the truck’s tailgate.
2. Remove the tent from the tent bag and lay it flat in the bed of
the truck. Locate the front door and place this end at the
tailgate with the other end towards the cab.
3. Locate the tent side straps (3 per side). Loosely attach each
strap to the truck’s body.
4. Locate the tent tailgate straps (3). Slide the 3 straps with the
male clip between the truck box and the tailgate (you may have
to lift the tailgate to do so). Connect the male clip strap to the
corresponding strap with the female clip.
6. Insert the poles into the corresponding color sleeve in the
below order. Note, the poles may get stuck on the pole sleeves.
Do not force the pole, simply lead them through the sleeve.
Do not place the poles in the pole pockets at this time.
A. Slide the BLACK POLE diagonally, corner-to-corner through
the pole sleeves in the roof of the tent. Repeat for the other
black pole
B. Slide the GREY POLE beneath the pole sleeve on the
roof of the tent, extending front to back
C. Slide the RED POLE into the corresponding pole sleeve
at the front (tailgate) of the tent
POLE
LOCATION
Black Poles (A)
Corner-to-Corner
Grey Pole (B)
Front-to-Back
Red Pole (C)
Vestibule/Tailgate
5. Assemble the tent poles by unfolding each section.
B
B
A
A
C
C
A
A
2016 Napier Outdoors
Rev. 01 12.01.15
2 of 6
