17
[37]System Reporting, Telco 1
(1)
Y
AC Fail Report
- Program to activate an
AC Fail report (15 minute fixed report delay).
(2) Low Battery
Report -
Program to
activate a Low Battery report.
(3) *Trouble Report
- Program to activate a
Trouble report.
(4) Reserved
*
Includes Bell Cut, Receiver Fail-to-
Respond, Receiver Tamper and Receiver
JAM. Point ID format will report trouble(s) by
device and ID number.
[38]System Restore Report, Telco 1
(1) AC Restore
- Program to activate an AC
Restore report.
(2) Battery Restore
- Program to activate a
Battery Restore report.
(3) Trouble Restore
- Program to activate a
Trouble Restore report.
(4) Reserved
[39]Opening/Closing Report, Telco 1
Select users required to send opening and
closing reports to Telephone Number 1. Do
not program for users that are intended to
send an
Opening After Alarm
(Cancel
Code) or
Conditional Closing
reports
Backup Telephone Programming
[40]Subscriber ID Number (Telco 2)
For 4/2 format enter a 4 digit number. If 3/1
format is required enter a 3 digit number
then press the
i
key.
[41]Telephone Number 2
Program the phone number to be dialed for
Telephone Number 2. A fixed dial tone
detection (E) is included prior to the Dialing
Prefix [44]. Dial tone detection can be
disabled by programming
No Dial Tone
Detection
[46-1]. To program any additional
delay enter a "D" where required in the
phone number.
[42]Receiver Format (Telco 2)
Select the format that will be used to report
for Telco 2 (Backup reporting). Refer to
section [32].
[43]Receiver Options (Telco 2)
Refer to section [33] Receiver Options.
[44]Dialing Prefix
Dialing prefix for Telco 1, Telco 2, and Telco
3. Program if using an Outside access
number.
[45]Communicator Features 1
(1) Communicator Enabled
- Program to
enable the communicator.
(2) DTMF with Rotary Backup
- The first
attempt to communicate is dialed using the
TouchTone method of dialing, subsequent
attempts are dialed using the pulse method
of dialing. Disable this feature to dial using
only rotary dialing.
(3) DTMF only
- All attempts to
communicate dial using the TouchTone
method of dialing.
(4) Backup Reporting to Telco 2
- After 2
attempts are made to communicate to Telco
1 the backup phone number is dialed (Telco
2).
[46]Communicator Features 2
(1) No Dial Tone Detection
- Program to
disable dial tone detection for Telco 1, Telco
2 and Telco 3.
(2) 2:1 Rotary Dialing
- Changes the make
break ratio when rotary dialing from 1.5:1 to
2:1.
(3) Backup if <4 attemps
- If
Backup
Reporting
[45-4] has been enabled, the
communicator will use
Telephone Number 2
[41] for the remaining retries when there are
less than 4 retries remaining.
(4) Reserved
