12
F I R E P R O T E C T I O N
(Applicable only where local ordinance permits use of this alarm control panel for fire protection.)
Fire-Zone Alarm
If a fire is detected, “
” will be displayed and the keypad sounder will
pulse.
1. If a fire is in progress, evacuate the premises immediately! If necessary, call the
Fire Department from an outside phone.
2. If there is no evidence of a fire, enter your code and press the
button to turn
off the alarm.
3. Press the
button to silence the keypad sounder.
4. Check smoke detector(s). If a smoke detector tripped, its red alarm indicator
light will be on.
5. After the alarm condition is corrected (thermostat cooled down; smoke cleared
from detector; etc.), pressing the
button again will reset the keypad within
about 10 seconds.
Fire-Zone Trouble
1. If a problem in the fire-circuit is detected, “
” will display and the
sounder will pulse to signal a malfunction.
2. Press the
button to silence the sounder. Call for service immediately!
GEM-RP1CAE2.pub
page 12
Tuesday, September 29, 1998 09:28
