3
1
2
3
N.C. EXTERNAL
CONTACT(S)
ON POINT 1
N.C. EXTERNAL
CONTACT(S)
ON POINT 2
REED
SWITCH
WIRING
The GEMC-WL-WD2 may be wired in any of the following configurations; refer to the diagrams below:
Note:
For Commercial and Resi-
dential Fire installations, only ONE initiating device may be connected to this transmitter (only normally open contacts used for Fire). For
Commercial Burglary installations, multiple initiating devices may be used as long as the devices all serve the same function (i.e. door, win-
dow, motion, etc.).
Notes:
1.
Caution:
Changes or Modifications not approved by Napco may void the user's authority to operate the equipment.
2. This device may not cause interference.
3. This device must accept any interference, including interference that may cause undesired operation of the device.
4. Only loop 1 is supervised.
J1 JUMPER INSTALLED
FUNCTION
External Contacts Enabled
for both point 1 and 2.
(DEFAULT)
1.
2.
J1 JUMPER NOT INSTALLED
FUNCTION
Internal Contact Enabled
for point 1. External contacts may be used for point
1 or point 2.
1
2
3
180K EOL
N.O. EXTERNAL
CONTACT TYPE
DEVICES SUCH
AS PULL STA-
TIONS, THERMAL
DETECTORS,
WATERFLOW
SUPERVISION
SWITCHES, ETC.
SHORT
POINT 2
1
2
3
180K
EOL
SHORT
POINT 2
REED
SWITCH
1
2
3
180K
EOL
REED
SWITCH
N.C. EXTERNAL
CONTACT(S) ON
POINT 2
180K RESISTOR
COLOR CODE (FROM LEFT TO RIGHT):
BROWN (1), GRAY (8), YELLOW (0), GOLD (5%)
1
2
3
N.C. EXTERNAL
CONTACT(S)
ON POINT 1
N.C. EXTERNAL
CONTACT(S)
ON POINT 2
A. FIRE Class B, Style A, B
B. BURGLARY
A. BURGLARY
B. BURGLARY
C. BURGLARY
180K EOL
180K EOL
SUPERVISED
LOOP
UNSUPERVISED
LOOP
(DO NOT USE)
SUPERVISED
LOOP
UNSUPERVISED
LOOP
SUPERVISED
LOOP
UNSUPERVISED
LOOP
SUPERVISED
LOOP
UNSUPERVISED
LOOP
SUPERVISED
LOOP
UNSUPERVISED
LOOP
