Supervised Alarm / Relay / Power Expansion Unit 22
Installing the Second Supervised Alarm/Relay (CICP1300IOBD) Board
Position the board so the outer mounting
holes line up. Then carefully align the
board over the four snap fasteners. Press
on the upper eight relays with your palm,
applying increasing force while rocking
your palm until all four snaps are secured.
Install the four 4-40 screws (provided) in
the mounting holes on the outer part of the
board.
Locate the
12V IN
connector on the upper-right of
the board.
When being installed in the CICP1300IOCOMBO
(with the power supply and battery) connect the small
white Molex Connector from the cable plugged into
RLY PWR OUT
Connector.
When installed in the CICP1300ENCL (without the
power supply and battery) use the long cable pro-
vided to connect to the Accessory Power Connector
in the Access Control Panel. Note this cable may be
routed with the Modular cable in the same conduit.
Connect the Short Modular Cable (provided) between
the two Alarm/Relay boards.
Locate the four
push-on "Snap"
Fasteners.
Locate the four 4-
40 female PEM
Fasteners.
INTERNAL EXPANSION
12V IN
Figure 17 - Fastener Mounting Locations
Figure 18 - Power Connection Locations
