DTW38 and DTW12
8
Rev. 02/27/15
TRAcK AND PeAK HolD oPeRATIoN
loW BATTeRY DISPlAY
When torque is applied, the real time torque value will be
displayed. After removing the applied torque, the LCD
display will flash the peak recorded value 5 times and then
automatically reset to the preset torque value.
• The LED's will track the measurement as force is applied
at 90, 100, and 110% of the set torque value. (90 is
indicated by a yellow LED, 100 is indicated by a green
LED, and 110 is indicated by a red LED.)
• If a slight amount of force is applied during the 5 flash
cycle the peak measurement will be shown for 1 min for
easy reference and viewing.
The LCD Display will show the condition in low battery.
oVeRloAD
• When the force applied is over 110% of the
maximum torque rating for the wrench, the red LED
light will blink and the LCD display will flash “FULL”.
• The ‘FULL” indication means the wrench needs to
be reset.
• Please press the "On/Off" key for 3 seconds to
power off the wrench and reset the "FULL" indicator.
