Napa Technology Customer Support 800.603.6550
Page 16
2.
Final Verification
Lift the bottle in the air about 1-2”, holding it
only by the head
. Gently pull up the
head a bit higher and lower it down a few times, to check if it holds the bottle properly.
If all has been done correctly the bottle should not slip out, and you should not feel
any looseness of the gasket inside the bottleneck.
If the bottle begins to slip, or the gasket feels loose, put the bottle down and do the
following:
1. Hold the head in place with one hand.
2. With your other hand,
fully
un-tighten the collar (until it touches the main body).
3. Remove the dispensing head from the bottle and detach it from the pickup tube.
4. Check the gasket for damage. If needed, replace with an undamaged head.
5. Check the correct gasket size. If needed, switch to a wider gasket size.
6. Wipe the gasket and inner part of the bottleneck dry, and try again.
Congratulations! You are now ready to insert the bottle into the WineStation.
Important:
When carrying around bottles
with the dispensing heads attached, always
hold the bottle itself (and not just the head),
as an extra safety precaution.
