TOUCH PANEL & REMOTE CONTROLS
Page 12 of 15
POWER
COLOR
FLAME
HEATER
TEMP.
TIMER
NOTICE
r is first turned on, a slight odor may be odor may be present. This is normal and
gain unless the heater is not used for a long period of time.
BUTTON
FUNCTION
ACTION & INDICATION
ON: Enables control panel functions and remote
control. Powers on flame effect.
OFF: Disables control panel functions and remote
control. Powers off flame effect.
COLOR: Change flame to 9 different colors
FLAME: control the brightness intensity of the flame
NOTE: Flame effect stays on until power button is
pressed to power off. Flame effect must also be
on in order to use heater.
HEATER: Powers heater on / off
NOTE: To prevent overheating, the heater fan will
blow cool air for 30 seconds after the heater button
used for for heater off
TEMPERATURE: Select temperature settings to
control optimal temperature range from 62 to 82
degrees (F).
TIMER: Select time range from 1 to 8 hours for
automated shutoff of the fireplace.
ON - Press once. Indicator light turns on.
Power turns on. All functions enabled.
OFF - Press once. All functions end.
Press to cycle through multiple color effects
Press once to decrease intensity. Press
again to dim to desired brightness.
Press once. Indicator lights up, 750W heater
powers on and blows warm air.
Press again. Indicator lights up, 1500W heater
powerts on and blows hot air.
Press again. Heaters power off. Fan blows cool
air for 30 seconds to cool down before power off.
Press once. Indicator lights up, Temperature
is set to 62 degrees (F).
Press until desired temperature is reached.
LED displays temp setting (62-82F).
Press once. Indicator lights up, Timer is set to
1 hour.
Press again until desired shutoff time is set. LED
displays timer setting (1-8) hours.
When the heater is first powered on, a slight odor may be present. This is normal and should
not occur again unless the heater is not used for a lengthy period of time.
NOTICE
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the
buttons too quickly. Remember to give the unit time to respond to each button press.
This heater is equipped with a Temperature Limitiing Control. Should the heater reach an unsafe
temperature the heater will automatically shut OFF.
To Reset after auto shutoff due to overheat:
1. Unplug the power cord from power outlet
2. Press the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint.
If the unit is blocked or clogged, use a vacuum with hose and crevice tool to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet
5. If the problem continues, have your outlet and wiring inspected by a professional.
TEMPERATURE LIMITING CONTROL
REMOTE CONTROL BATTERY REPLACEMENT
Remote control requires two (2) AAA batteries.
