Connecting to watch TV, VCR or DVD
To view television channels directly, a signal must be received by the set from one of following
sources:
An outdoor aerial
An indoor aerial (not recommendable)
A cable television network
1. In the first three cases, connect the aerial or network input cable to the 75 ohm coaxial socket
on the rear of the TFT LCD TV.
2. Press the TV button on the remote control.
1. Connect video and audio cable according to the shape and color or the video / audio cable.
When an external devices is in MONO, the audio connection cable can be connected to
either the left and S.MODE / MTS should be set MONO.
2. For optimal visual image, use COMPONENT connector instead of video connector.
Connecting the Aerial or Cable Television Network
Connecting the VCR, DVD or Other external devices
Basic Remote Control Operation
P.STD Button
By pressing the P.STD button, sequentially select one of the 4 pre-sets picture standard.
•
Standard : Select this mode to watch TV at standard state.
•
Dynamic
: Select this mode to watch in a room with bright illumination.
•
Mild
: Select this mode when the room is dark or to lessen eye fatigue.
•
User
: Select this mode to view the picture to your set picture state preference.
S.STD Button
Whenever this button is pressed, the mode will be changed as follows.
STANDARD
MUSIC
MOVIE
SPEECH
USER
Sleep Button
The television is automatically turned off after an elapse of the set sleep time.
1) The set time ranges from 10 to 180 minutes, which is repeated in sequence each time
you press.
2) If you'd like to check the remaining SLEEP TIME after OSD disappears, press DIS-
PLAY button.
OFF
→
10
→
30
→
60
→
90
→
120
→
150
→
180
LIFT (
▲
▲
) / (
■
■
)/ (
▼
▼
) Button
1) Press the
▲
▲
button when you to move up lift.
2) Press the
■
■
button when you to move stop lift.
3) Press the
▼
▼
button when you to move down lift.
