)
)
**
Setup Setting
Search Setup
It is used for channel search.
Start Search : It starts channel search.
System : Select ATV Auto Search Mode
Auto Search : Auto Search the ON/OFF
Manual Search 1 : It selects channel the DTV
Manual Search.
Manual Search 2 : It starts the ATV Manual Search.
There are two methods of Automatic Tuning and
Manual Tuning how to tune.
Automatic Tuning
•
You should display the Main Menu, pressing the
menu key of remote control.
•
You should select the Search Setup menu of the
Main Menu, pressing the CH
▲▼
key.
•
You should enter to the Search Setup menu,
pressing the ENT key.
•
After selection the Start Search menu using the
CH
▲▼
key, Channel search begin as pressing
the ENT key.
(System : Pal/Secam Auto search: On, Manual Search 1: All)
You can scan the frequency ranges available on your
television in your country and store all the channels found
automatically.
The channels are stored in the order in which they
appear in the frequency bands. It is possible that the
automatically allocated numbers may not correspond to
those by which you wish to identify the channels.
If this is the case, you can then sort them manually.
Selecting the Sound Mode
(depending on TV mode)
The "M/S" button displays/controls the processing and output of the audio signal.
When power is switched ON, the mode is automatically preset to either "Dual" or "Stereo"
depending on the current transmission.
●
If the receiving conditions deteriorate, listening will be easier if the mode is set to the "Mono"
position using the M/S button.
●
If the stereo signal is weak (or if intermittent Stereo-Mono) and automatic switching occurs,
then switch to the "Mono" mode.
●
When receiving mono sound in the AV mode, connect to the "L" input jack on the panels. If
the mono sound comes out only from the left speaker, then press the M/S button.
You can adjust the volume by pressing the VOL[ + ] or
VOL[ - ] button on the remote control.
You can switch the sound off temporarily by pressing
the MUTE button on the remote control, for example
you may wish to answer the telephone.
1. Press the VOL[ + ] button to increase the volume.
(cursor moves to the right)
2. Press the VOL[ - ] button to decrease the volume.
(cursor moves to the left)
3. Press the MUTE button.
Result : The sound is switched off and
"
Mute On" is displayed.
4. When you wish to turn the sound back on at the
same volume as before, press the MUTE button
again (or either of the volume buttons).
Adjusting the Volume/Switching the Sound Off Temporarily
