2 Safety and warning notices
2 Safety and warning notices
WARNING
!
Risk of overheating or fire if the limits defined in the technical data (see
) are not observed and there is insufficient cooling!
►
Do not use the product in potentially explosive areas (EX areas).
►
During use, make certain that the cooling and environmental conditions are ensured.
►
Ensure that good heat dissipation is favored by either installing the device in vertical position
or —if in a horizontal position— with the metal housing on top.
►
Ensure that the permissible current is not exceeded when choosing an
.
►
Monitor the status during commissioning and operation, via the
CAUTION
!
Risk of injury from electric shock if the product is damaged!
If the product is damaged, voltage carrying parts can cause an electric shock which can possibly
lead to burns and injuries.
►
Only change the wiring or touch the product in a de-energized state. After switching off, wait
at least three minutes until the voltage in the capacitors has dissipated.
CAUTION
!
Risk of injury in case of a short circuit!
A short circuit can damage the product and possibly lead to burns and injuries.
►
If you notice a short circuit or the product signals an error via the
, immediately switch off the power supply. Commision the product again in a protected
environment and check the
,
CAUTION
!
Risk of burning!
The product may become very hot during operation
►
During use, make certain that the cooling and environmental conditions are ensured.
►
Do not touch the product while in operation. After switching off, wait until all components have
cooled before you touch them.
CAUTION
!
Risk of injury from sharp edges!
Due to production tolerances, sharp edges may form on the DIN rail clip and the mounting lugs
that could cause hand injuries.
►
Do not touch the DIN rail clip or the mounting lugs to unpack or mount the product.
Version: 1.2.0
6
