Please read this safety information carefully and keep this user manual for later reference.
Nanoleaf Aurora is not designed for use in:
• Enclosed locations that limit the flow of air and/or trap excessive amounts of heat
• Emergency exits or emergency lights
• Conjunction with 3rd party sensors/timing devices that are not approved by Nanoleaf®
• Places where there is a risk of electric shock
• Outdoor areas
• Wet or damp conditions
• Excessively hot environments (e.g. close to ovens, radiators, heaters, etc.)
• Regions or countries other than that in which the product was intended for.
• Do not open the device, as this will void the warranty.
• Do not place any metallic or conductive objects near the exposed contacts on the
Aurora controller, power supply, linkers, or back of the Aurora panels.
• Do not allow small children to operate this device unsupervised. This device contains
small parts that may be a choking hazard to small children.
• Do not clean the device when it is on and or connected to power.
• Clean the panels with a soft dry cloth, do not use cleaning agents.
• Do not bend the panels with the linker still attached.
• Do not attach the panels together with anything other than its original panel linkers.
• Do not puncture the panels with any nails or screws during installation.
• Do not attach the panels to a ceiling without consulting a qualified contractor and using
additional mounting hardware designed to prevent the panels from falling.
• Do not attach the panels to the floor where they may get stepped on.
• Do not place the panels in water, or expose the panels to water.
• Do not use mounting tape for the following surfaces: brick or mortar wall, wallpaper,
uneven/bumpy or textured surfaces.
• Do not attach the panels to a ceiling without consulting a qualified contractor and using
WARNINGS & CAUTIONS
When using Nanoleaf Aurora:
as a result of modi cations to the product or by failure to adhere to the “Warnings and
Cautions” section of this document.
This device generates radio frequency energy and, if not installed in accordance with
the “recommended installation requirements” may cause harmful interference to radio
communication devices. If the device is causing radio interference, it is recommended
that the user try: a) relocating the device to a different place; b) adjust the antenna on
the receiving device; c) consult a technician experienced in radio interference.
