Nannio FollowMe, User Manual

Page: 12 / 52

Monitor Setup
Power Supply
The monitor uses 3.7V 2600mAh (Li-ion) battery or the household AC power
current.
Changing the Battery
1. Open the battery compartment cover on the rear of the monitor (See Fig. 5).
2.
Pull out the battery and remove the cable. Re-attach the cable with new
battery (See Fig. 4).
3.
Close the battery compartment cover, and make sure it is locked securely.
4. Press the POWER button and keep it around 3 seconds to turn the
monitor on (See Fig. 4).
Note 1: When power is sufficient, the "Power/Charging" LED will light up
(green light); When battery is low, the red LED light will start blinking.
2
Setup
Camera Setup
Power Supply - Using AC Power
1. Plug one end of the provided power adapter into a wall outlet and the other
end into the back of the camera. See Fig. 3.
Note :
Use the adapter labeled OUTPUT: 6V DC with the camera.
2. Press the POWER button less than 1 second to turn on the camera.
The LED on the camera will light up (green light). See Fig. 3.
Note : Press the POWER button less than 1 second to turn off the
camera.
Fine Tuning
Place the camera in a convenient location, point the lens toward the observation
area.
Night Vision
The camera has eight high-intensity LEDs for picking up clear images in the
dark. When the light sensor detects low ambient light levels, the LEDs will be
automatically activated.
Room Temperature Measurement
Temperature sensor can measure room temperature on camera side and the room
temperature indicator will be displayed on the screen of the monitor unit.
1
1
.1
1
.2
1
.3
1
.4
2
.1
2