Nanni Q1500 Series, User Manual

Page: 57 / 98

57
S 07 MAINTENANCE
ENGINE OIL REPLACEMENT
DANGER!
When changing or inspecting, be sure to level and stop
the engine.
ENVIRONMENT!
Use a suitable container. Used oil must be disposed of in
accordance with national and international laws and reg-
ulations.
• Remove the oil dipstick
• Insert a hose connected to an electric pump in-
side the hole.
• When draining is complete, remove the hose and
electric pump.
• Put the oil dipstick back on
Oil filling
• Open the oil filler cap (3) and fill with new oil to the
top mark on the dipstick (Maxi). Then close the
oil filler cap and run the engine for a few minutes;
stop the engine and check the level again. Adjust
the oil level if necessary.
IMPORTANT !
When using a different brand or viscosity of oil, remove
all the old oil. Never mix two different types of oil. Use the
proper SAE engine oil for the ambient temperature.
Above 25 °C (77 °F)
SAE 30 or SAE 10W-30
SAE 10W-40
0 °C to 25 °C (32 °F to 77 °F) SAE 20 or SAE 10W-30
SAE 10W-40
Below 0 °C (32 °F)
SAE 10W or SAE 10W-30
SAE 10W-40
Engine oil capacity in liters (US Gal)
Volume
5.1 (1.35)
Fuel type
Classification of engine oils
(API Classification)
High sulfur fuel [0.05% (500
ppm) ≤ sulfur content <
0.50% (5000 ppm)].
CF (If “CF-4, CG-4, CH-4, or CI-
4” engine oil is used with high
sulfur fuel, change the engine
oil at shorter intervals. (About
half))
Low sulfur fuel (sulfur con-
tent < 0.05% (500 ppm)) or
ultra low sulfur fuel (sul-
fur content < 0.0015% (15
ppm)).
CF, CF-4, CG-4, CH-4 or CI-4