Nanni N4.40, Workshop Manual

Page: 25 / 175

GENERAL
03-M-E3B, 03-M-DI-E3B, 03-M-E3BG, WSM
G-10
[2] CHECK POINTS FOR THE INITIAL 50 HOURS
Change of Engine Oil
CAUTION
• Make sure that you stop the engine before you change the
engine oil.
1. Start and warm-up the engine for approximately 5 minutes.
2. Put an oil pan below the engine.
3. Remove the drain plug (1) at the bottom of the engine and drain
the oil fully.
4. Tighten the drain plug (1).
5. Fill new oil until the upper line on the dipstick (2).
IMPORTANT
• When you use an oil of different brand or viscosity from the
previous, drain the remaining oil. Do not mix 2 different
types of oil.
• Engine oil must have the properties of API classification
CF/CF-4/CG-4/CH-4/CI-4.
• Use the correct SAE Engine Oil by reference to the ambient
temperature.
*90 mm (3.5 in.) oil pan depth is optional.
M00000003GEG0010US1
Above 25 °C (77 °F)
SAE 30 or
SAE 10W-30, SAE 10W-40
0 °C to 25 °C (32 °F to 77 °F)
SAE 20 or
SAE 10W-30, SAE 10W-40
Below 0 °C (32 °F)
SAE 10W or
SAE 10W-30, SAE 10W-40
Models
Oil Pan Depth
124 mm (4.88 in.) *90 mm (3.5 in.)
D1503-M, D1703-M,
D1803-M, D1803-M-DI,
D1703-M-BG
7.0 L
1.8 U.S.gals
5.6 L
1.5 U.S.gals
V2003-M, V2203-M,
V2403-M, V2403-M-DI,
V2403-M-DI-T,
V2003-M-BG,
V2003-M-T-BG,
V2203-M-BG, V2403-M-BG
9.5 L
2.5 U.S.gals
7.6 L
2.0 U.S.gals
V2403-M-T
9.5 L
2.5 U.S.gals
–
(1) Drain Plug (2) Dipstick
KiSC issued 06, 2009 A