61
Locators on fuel filter canisters must be indexed properly
with slots in mounting base for correct installation.
9. Lubricate new primary fuel filter seal with thin film of
clean fuel.
10. Screw primary fuel filter into header until the seal
contacts the fuel filter header.
11. When seal contacts the fuel filter header, tighten
until a “click” is heard.
12. Connect water-in-fuel sensor connector (
C
).
13. Remove secondary fuel filter (
A
) using a suitable
filter wrench.
14. Lubricate new secondary fuel filter seal with a thin
film of clean fuel, and screw filter into fuel filter header
until the seal contacts the fuel filter header.
15. When the seal contacts the header, tighten until a
“click” is heard.
16. Open fuel supply shutoff valve (if equipped).
17. Turn ignition key to the ON position for 120 seconds
to allow the fuel system to prime itself.
18. Start engine and allow to run for a minimum of 5
minutes.
Legend :
A : Secondary fuel filter
B : Drain bolts
C : Water in fuel connector
D : Primary fuel filter
DRAINING WATER FROM FUEL FILTERS
If instrument panel provides a water in fuel warning, drain
water or debris from filter using the following steps:
1. Loosen thumb screw (
B
) and drain water and debris
into a suitable container. Tighten thumb screw.
2. Dispose of water and debris in an environmentally
safe manner.
REPLACING THE FUEL FILTERS
NOTE !
Primary and secondary fuel filters must be replaced both
at once, whenever audible alarm sounds and diagnostic
trouble code indicates a plugged filter (fuel supply
pressure moderately/extremely low).
1. Close fuel shutoff valve (if equipped).
2. Clean entire area surrounding fuel filter assembly to
keep debris from entering fuel system.
3. Disconnect water-in-fuel outlet connector (
C
).
4. Open drain valve (
B
) and drain fuel from water
separator into a suitable container.
5. Remove primary fuel filter (
D
) by hand or in using a
suitable filter wrench.
6. Remove water separator bowl, if equipped, from
primary fuel filter by hand or in using a suitable strap
wrench.
7. Clean separator bowl and dry it.
8. Lubricate new water separator bowl seal with thin film
of clean fuel, and hand tighten to primary fuel filter.
S08
MAINTENANCE
Summary of Contents for N13.430 CR2
