14
2. DMX Remote Control
①
Connect the fixture to the DMX/RDM consoles via DMX cable as shown below:
DMX IN
DMX OUT
1 GND
2 DATA-
3 DATA+
NC
NC
NC
NC
GND 1
DATA- 2
DATA+ 3
·
The connection between light fixtures, or light fixture and DMX/RDM console, must use five core shielded cable.
Make sure its diameter is not less than 0.3mm. XLR plug/socket and the wire should be connected as shown
above.
·
Pin1, Pin2, Pin3 for connecting DMX signal. Pin4, Pin5 has no connection.
▲NOTE: When connecting DMX, make sure the internal pin is not in contact with the inner case. The fixture can
match the DMX512 (1990) control signal.
·
Plug of 5-Pin and 3-Pin XLR plug/socket conversion. The fixture is supplied with 5-Pin XLR plug. lf using a 3-Pin
XLR plug, please follow the instructions below.
5PIN
Pin 1:GND(SCREEN)
Pin 2:Signal(-)
Pin 3:)
Pin 4:N/C
Pin 5:N/C
3PIN
Pin 1:GND(SCREEN)
Pin 2:Signal(-)
Pin 3:)
