![background image](http://html1.mh-extra.com/html/namco/exceleena/exceleena_instructions-manual_3166287008.webp)
4.
※
If the floor is not flat, use the two level adjusters on the front side to adjust
the level
(Adjustable range is 0 to +18 mm. Do not raise any higher than 18mm)
Important: to prevent damage always fully retract the level adjusters
before moving the machine
(1)
Loosen the two M5 base guard nuts
to loosen the Signboard Osae (clamp)
(It is not necessary to completely remove the nuts.)
(2)
Insert the Signboard assembly between the signboard base and the Signboard Osae.
Tighten
the two M5 base guard nuts to
secure
Important : Please remove the Signboard Assembly when transporting or moving. Again by loosening
the M5 base guard nuts
After removal of the Signboard assembly tighten the M5 base guard nuts
again
so that they will not
come off and be lost.
Signboard assembly
Base guard
Nut
(M5)
Signboard base
カンバンオサエ
Signboard osae
(clamp to hold down)
Figure 1
- 6 -
4
2
Installation of Signboard
4
1
Adjusting the level adjuster
Setup
Summary of Contents for EXCELEENA
Page 19: ...8 Parts List 18 l 1 7...
Page 22: ...Wiring Diagram...