Nakayama PS5000, Manual

Page: 12 / 37

108
NOTE
• Disassembly of the pole pruner/strimmer/3-
section cutting blade/extension attachment is
carried out in the same order.
Swivelling the hedge trimmer
• Release the lock/release .
• Press the control lever and swivel the hedge
trimmer into the desired position.
• Allow the control lever to click into the recess in
the base plate (hedge trimmer) .
Mounting the saw chain and blade
WARNING!
• Wear protective gloves! There is a danger of
injury from the sharp cutting teeth.
NOTE
• Pay close attention to the running direction of
the saw chain on the blade and at the sprocket
cover .
• Depending on wear, the blade can be turned.
• Undo the nut using the open-ended spanner.
• Remove the sprocket cover .
• Lay the saw chain over the blade starting at the
tip.
• Now fit the blade and saw chain .
• Lay the guide rail over the blade guide while
inserting the chain tensioner pin in the blade
hole . At the same time, lay the saw chain over
the chain sprocket .
• Now you can tighten the saw chain
• Replace the sprocket cover and tighten the nut
gently.
Removing the saw chain
• You may have to loosen the saw chain to
remove the blade and the saw chain.
Follow these instructions in reverse order.
Tightening and checking the saw chain
WARNING!
• Wear protective gloves! There is a danger of
injury from the sharp cutting teeth.
• Turn the chain-tensioner screw in a clockwise
direction using the flat-blade screwdriver 7! to
increase the tension.
• The saw chain must lie against the underside of
the blade. Check whether the saw chain can be
drawn by hand over the blade .
NOTE
• A new saw chain stretches and must be
tightened more regularly.Lubricating the chain
• Remove the oil filler cap .
• Fill the oil tank with approx. 100 ml of organic
chain oil 6%.
• The chain lubrication can be increased or
decreased using the oil adjusting screw .
• Press and then turn the oil adjusting screw
clockwise to increase the chain lubrication.
• Press and then turn the oil adjusting screw
anticlockwise to decrease the chain lubrication.
WARNING!
• Never work without chain lubrication! If the
saw chain runs dry, the cutting equipment may
become irrepar-ably damaged in a short time.
Always check chain lubrication and oil level in the
tank before starting work.
NOTE
• Use only saw chain oil. Preferably biodegradable.
Do not use waste oil, motor oil, e
tc.
• While working, check whether the chain
lubrication is working correctly.Sharpening the
saw chain
NOTE
• A grinder can be attached to the grinder
support for a secure grip during grinding. ■You
will find detailed information on sharpening
in the sharpening set, e.g. from Oregon. •
Alternatively, you can use an electrical saw chain
sharpening device and follow the manufacturer's
instructions .
• If you have any doubts about carrying out the
work, the saw chain should be replaced.Attaching
the extension attachment
CAUTION!
• Do not use the extension attachment/boom in
combination with the 3-section cutting blade/
strimmer attachment!