EN
WWW.NAKAYAMATOOLS.COM
5
Maintenance Precaution
WARNING – Never operate an earth auger that is damaged, improperly adjusted, or is not completely and securely assembled.
WARNING – Be sure that the bit stops moving when the throttle control trigger is released. If the bit moves at idle speed, the carburettor may need adjusting,
see “Operation-Carburetor Adjusting”.
Section. If the bit moves at idle speed after adjustment has been made, contact a Servicing Dealer for adjustment and discontinue use until the repair is made.
• Never modify your earth auger in any way.
• Keep the handles dry, clean, and free of oil or fuel mixture.
WARNING – Use only accessories and replacement parts recommended.
• Never touch the bit or attempt to service the earth auger while the engine is running.
• Never use fuel for cleaning operations.
• Keep the earth auger in a dry place, off the ground with the tanks empty.
• If your earth auger is no longer usable, dispose of it properly without damaging the environment by handing it in to your local Dealer who will arrange for its
correct disposal.
• Replace immediately any safety device when damaged or broken.
WARNING – The muffler and other parts of the engine (e.g. fins of the cylinder, spark plug) become hot during operation and remain hot for a while after stop
-
ping the engine. To reduce risk of burns do not touch the muffler and other parts while they are hot.
① Starter
② Fuel Tank
③ Engine
④ Stop Button Comp
⑤ Throttle Lever
⑥ Grease Cap
⑦ Auger Bit
Description of main parts (Pic.A)
Technical Data
Model
PD6320
Displacement
63,3 cm
3
Operation
Double
Drill diameter
100/150/200/250/300 mm
Power output
2 kW
Revolutions per minute
7500 RPM
Assembly
Fit the reduction shaft (C) into the seat on the bit (D) and secure it using the appropriate gudgeon pin (A) and
(B).
Operating instructions
Before start
(1) Take care that no person is in the surrounding environment while you are working (or at least in a safe distance).
(2) Check the earth auger in detail. Don’t work with the auger if something on the machine doesn’t look or works as expected.
(3) Turn the accelerator switch to the lowest position.
(4) Add fuel in a safe distance (3m) from the machine for safety purposes.
Mixing Ratio
Add 30ml of oil (2-stroke air cooled engine lubricant) per 1 litre of 95 octane unleaded gasoline in a special fuel container and mix thoroughly.
