10
WWW
.N
AKAYAMA
T
OOLS
.
COM
any other part, or when replacing the oil or any lubricant,
always be sure to use only ORIGINAL
products which have
been certified
by the manufacturer.
4. In the event that any part must be replaced or any
maintenance or repair work
not described
in this manual
must be performed, please contact a representative from
the store nearest authorized servicing dealer for
assistance.
5. Do not use any accessory or attachment other than
those which the manufacturer recommends
and
recommended for the unit.
6. Under no
circumstances should you ever take apart the
product or alter it in any
way. Doing so might result in the
product becoming damaged during operation or the
product becoming unable to operate properly.
HANDLING FUEL
1. The engine
is
designed to run on a mixed fuel, which
contains highly flammable gasoline. Never store cans of
fuel or refill the tank of the unit in any place where there is
a boiler, stove, wood fire, electrical sparks, welding
sparks,
or any other source of heat or fire which might ignite the
fuel.
2. Never smoke while operating the unit
or refilling its fuel
tank.
3. When refilling
the tank, always turn off the engine and
allow it to cool down. Take a careful look around to make
sure that there are no sparks or open flames anywhere
nearby before refueling.
(1) Refill after cooling the engine.
4. Wipe spilled fuel completely using a dry rag if any fuel
spillage occurs during refueling.
5. After refueling, screw the fuel cap back tightly onto th
e
fuel tank and then carry the unit to a spot 3 m
or more
away from where it was refueled before turning on the
engine.
6. Do not inhale fuel fumes as they are toxic.
TRANSPORTATION
1. When ha
nd-
carrying the product, cover over the cutting
part if necessary, lift up the product and carry it paying
attention to the blade.
2. Never transport the product over rough roads over long
distances by vehicle without removing all fuel from the
fuel tank.
If doing so, fuel might leak from the tank during transport.
Fuel
FUEL
WARNING
Gasoline is very flammable.
Avoid
smoking or bringing any flame or sparks
near fuel. Make sure to stop the engine
and
allow it cool before refueling
the unit.
Select outdoor bare ground for fueling
and move at least 10 ft (3 m) away from
the fueling point before starting the
engine.
GASOLINE REQUIREMENTS
All 2
-
Stroke Products are powered by
Professional
-
Commercial Duty, Hi
-
Performance, Hi
-
RPM, Air
Cooled 2
-
Stroke engines.
Hi-
Performance 2
-st
roke engines produce
higher HP outputs as compared to
standard Home Owner Duty or Light
Commercial Duty production engines
offered
by most manufacturers.
Exhaust emission are controlled by the
fundamental engine parameters and
components (eq., carburation, ignition
timing and port timing) without additio
n
of any major hardware or the
introduction of an inert material during
combustion.
Summary of Contents for PH2300
Page 18: ......