10
5 Carburetor
11
Blade cover
6 STOP Switch
（
ON-OFF
）
FUELS/REFULLING
Fuel and oil mirture
Inspect the fuel tank and with clean, fresh fuel of the proper mixture to assure the longer life of the tool. Use the following mixed gas
Gasoline: applicable genuine two-stroke engine oil = 25:1
Gasoline: other manufacturer’s two-stroke engine oil = 25:1 recommended
FOR CALFORNIA REGULATION:
THIS EQUIPMENT IS CERTIFIED TO OPERATE ON G TWO- STROKE ENGINE OIL
IMPORTANT:
Failure to follow proper fuel mix instructions may cause damage to the engine.
--The engine of the Hedge Trimmer is a high-efficiency two-stroke engine.
It is run with a mixture of fuel and two-stroke engine oil. The engine is designed for
unleaded regular fuel with a min. octane value of 91 ROZ.
In case no such fuel is available. You are use fuel with a higher octane value. This will not
damage the engine, but may cause poor operating behavior.
A similar situation will arise from the use of leaded fuel.
To obtain optimum engine operation and to protect your health and the environment,
only unleaded fuel should be used.
--For lubricating the engine use two-stroke engine oil (quality grade TC-3). This is added
to the fuel.
The engine has been designed for use with applicable two-stroke engine oil and a mixture
ratio of 25:1 only to protect the environment in addition, a long service life and a reliable
operation with a muumuu emission of exhaust gasses is guaranteed. It is absolutely
essential to observe a mixture ratio of 25:1 (applicable 2-stroke engine oil). Otherwise
the reliable function of the Hedge Trimmer cannot the guaranteed.
--The correct mixture ratio:
Mix 25 parts gasoline with 1 part applicable 2-stroke engine oil (see table on the right).
NOTE: For preparing the fuel-oil mixtures first mix the entre, oil quantity with half o the
fuel required. In an approved can which meets of exceed all local code standards then add
the remaining fuel.
Thoroughly shake the mixture before filling it into the Hedge Trimmer’s tank.
It is not wise to add more engine oil than specified to ensure safe operation. It will only
result in a higher production of combustion
residues which will pollute the environment
and clog the exhaust channel in the cylinder as
well as the muffler. In addition, the fuel
consumption will rise and performance will
decrease.
Handling petroleum products
Utmost care required when handing fuel. Fuel
may contain substances similar to solvents.
Refuel either in well ventilated area or outdoors.
Do not inhale fuel vapors, avoid contact of fuel
or oil with your skin.
Mineral oil, fuel, etc. product degrease your skin.
If skin comes in contact with these substances
repeatedly or an extended period of time,
various skin diseases may result. In addition,
allergic reactions are known to occur. Eyes can
be irritated by contact with oil, fuel etc. oil fuel,
etc,. Comes into your eyes immediately wash
them with clear water. If your eyes are still
irritated, see a doctor immediately!
