This machine can be set to five height of cut.
I=25mm II=35mm III=45mm IV=55mm V=65mm
• Pull Height adjustment lever to the broadside.
•Push the adjustment lever to the front or back.
• When the adjustment lever is in the front, the height is the toppest, when in the back, the height is the lowest.
Note: For long grass, start mowing with the highest
setting and then gradually reduce the height of cut.
Warning:
When mowing, do not allow the motor to labour, particularly in heavy conditions.
When the motor labours the revolutions of the motor will drop and you will hear a change in the motor sound.
When this occurs stop mowing, release the switch lever and raise the height of cut. Failure to
do so could damage the machine.
NOTE:
The motor is protected by a safety cut–out switch which is activated when the blade becomes jammed
or if the motor is overloaded. When cut-out occurs, stop mowing and disconnect the lawn mower from the
power supply. Clear any obstruction and wait for a few minutes for the safety cut out switch to reset before
continuing to use the mower. If the mower cuts out again increase the height of cut to reduce the load on the
motor.
NOTE:
The temperature of the motor will rise quickly,
if the lawn mower frequently jams. If the motor overheats, the safety cut out switch will operate and will cut off
the power. If this occurs, you will need to disconnect the lawn mower from the power supply and wait for it to
cool down completely. You will need to wait for approximately
1
hour before you can start using the mower
again.
Note: All item numbers in bold refer to the illustration on page 5.
Blade Replacement
• Switch off the lawnmower and disconnect from the mains supply.
• Before replacing the blade it is advisable to thoroughly clean the underside of the machine.
• Always wear work gloves when replacing the blade. Note which way the blade is fitted. Hold the blade firmly
with one hand and using the spanner to remove the blade securing bolt anticlockwise.
Remove the blade and thoroughly clean the area around the shaft.
• To attach the new blade (QT3041 400mm), align
the blade onto the drive shaft ensuring that the mark on the blade is on the outside and the two studs on the
back of the fan are located into the corresponding two holes in the blade. Tighten blade securing bolt clockwise,
do not over tighten.
Check to ensure the blade is located correctly before using the lawnmower