WWW.NAKAYAMATOOLS.COM
EN
6
ASSEMBLY
WARNING:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheading therein
before set up or use of this product.
BLOWER ASSEMBLY:
1. Slide the blower tube forward until the notched area on the blower housing clicks into the slot on the blower tube.
2. Insert the concentrator nozzle onto the end of the blower tube until it locks into position (
Fig. 1
).
NOTE: The concentrator nozzle is used to increase air flow in tight areas (i.e around flower beds, under decks, etc.).
3. Before using the blower function, rotate the lock knob to lock the cover in place (The indicator will be on the far right position,
Fig. 2
).
4. To remove the blower tube, turn the ON/OFF power switch to the OFF (O) position and disconnect the tool from the power supply (
Fig. 3
).
5. Press the tube release button and remove the blower tube (
Fig. 4
).
VACUUM/MULCHER ASSEMBLY:
1. Slide the front and rear vacuum/mulcher tubes together until the lock button engages (
Fig. 5
).
2. Rotate the lock knob to unlock the cover (The indicator is on the far left position,
Fig. 6
).
3. With the blower tube removed, insert the “hooked” side end of the mulcher tube into the rear clip on the unit. Rotate the lock knob to close the front tube
(The indicator is on the far right position,
Fig. 7
).
4. Make the inter cover hook the hook of the rear tube (
Fig. 8
).
5. Insert the collection bag adaptor into the blower air outlet until the collection bag is securely fastened (Fig. 9), then make the bag hook the strap holder on
the two sides of the tube (
Fig. 10
).
6. To remove the collective bag, release the bag from the strap holder on the two sides of the tube, and simply press the tube release button to remove the bag
(
Fig. 11
).
7. To remove the vacuum/mulcher tube assembly, release the inter cover from the hook of the tube, rotate the lock knob to unlock, then remove the tube as
-
sembly from its housing (
Fig. 12
).
NOTE: It may be necessary to remove the blower tube or vacuum/mulcher tubes to clear a blocked tube or impeller.
8. Make sure to disconnect the unit from the power supply before attempting to clear any obstructions. The indicator of the lock knob must be entered into black
area first, then the machine can be running (
Fig. 13
).
OPERATION
WARNING:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this manual including all text under subheading therein before
set up or use of this product.
CONNECTING TO A POWER SOURCE
1. Secure the extension cord to the motor housing using the cord retainer located at the rear of the blower. Securing the extension cord in this manner pre
-
vents accidental removal of the electrical cord during operation (
Fig. 14)
.
2. Plug the female end of the electrical cord into the receptacle at the back of the unit.
STARTING AND STOPPING
1. To start the electric blower/vacuum/mulcher, slide the ON/OFF switch to position (1),This unit is equipped with one speed settings (1 ) (
Fig. 15
).
2. To stop the unit, slide the ON/OFF switch to position (0) (
Fig. 15
).
