NAiS KT7, Instruction Manual

Page: 12 / 26

Sensor correction setting
•
Sets the sensor correction value for the sensor.
• Thermocouple and RTD inputs: –100.0 to 100.0 ( )
DC voltage and current inputs: –1000 to 1000 (The placement of
the decimal point follows the selection)
0.0
5.5 Auxiliary function setting mode 2
Character Name, Description, Setting range Default value
Input type selection
•
The input type can be selected from thermocouple (22 types),
RTD (8 types), DC current (2 types) and DC voltage(4 types),
and the unit / can be selected as well.
K
(–200 to 1370 )
K –200 to 1370 :
–199.9 to 400.0 :
J –200 to 1000 :
R 0 to 1760 :
S 0 to 1760 :
B 0 to 1820 :
E –200 to 800 :
T –199.9 to 400.0 :
N –200 to 1300 :
PL- 0 to 1390 :
C (W/Re5-26)0 to 2315 :
Pt100 –199.9 to 850.0 :
JPt100 –199.9 to 500.0 :
Pt100 –200 to 850 :
JPt100 –200 to 500 :
K –320 to 2500 :
–199.9 to 750.0 :
J –320 to 1800 :
R 0 to 3200 :
S 0 to 3200 :
B 0 to 3300 :
E –320 to 1500 :
T –199.9 to
750.0 :
N –320 to 2300 :
PL- 0 to 2500 :
C (W/Re5-26) 0 to 4200 :
Pt100 –199.9 to 999.9 :
JPt100 –199.9 to 900.0 :
Pt100 –300 to 1500 :
JPt100 –300 to 900 :
4 to 20mA –1999 to 9999:
0 to 20mA –1999 to 9999:
0 to 1V –1999 to 9999:
0 to 5V –1999 to 9999:
1 to 5V –1999 to 9999:
0 to 10V –1999 to 9999:
Scaling high limit setting
•
Sets the scaling high limit value.
• Setting range: Scaling low limit value to input range high limit
value
(For DC voltage and current inputs, the placement of the
decimal point follows the selection.)
1370
Scaling low limit setting
•
Sets the scaling low limit value.
• Input range low limit value to scaling high limit value
(For DC voltage and current inputs, the placement of the
decimal point follows the selection.)
–200
Decimal point place selection
•
Selects decimal point place.
• Available only for DC input.
• No decimal point, 1 digit after decimal point
2 digits after decimal point, 3 digits after decimal point
No decimal
point
PV filter time constant setting
•
Sets PV filter time constant.
(If the setting value is too large, it affects control result due to
the delay of response)
• Setting range: 0.0 to 10.0 seconds
0.0 seconds
OUT high limit setting
•
Sets the control output high limit value.
• Not available for ON/OFF action.
• Setting range: OUT low limit value to 105%
(Setting greater than 100% is effective to DC current output type)
100%