5
Nagra –
300i / 300p
Setting-up the amplifier
Introduction to set-up
It is recommended to wear Nagra gloves to manipulate the amplifier and the
accessories. It is mandatory when handling the 300B tubes as hand prints can
affect the tube in the long-term.
Place the amplifier on the
VFS platform
on a perfectly flat and stable surface.
Provide enough space above the amplifier to allow air to circulate as the tubes
run quite hot.
Remote device number and RC-5
If you wish to change the amplifier device number or if
you want to use a RC-5 compatible remote, do so
before assembling the amplifier.
By default, the 300i device number is 5. You may change this
setting to any number from 1 to 6.
Using Nagra gloves, turn the amplifier upside down and put it
on a soft surface.
Remove the plastic protection that hides the access hole to the
selector.
Using the ceramic screwdriver,
change the selector to the
desired number.
Selector position
Device
0
Code
Category
Group
Philips RC-5
Preamp Audio 1
16
1 to 6
Nagra device number
