7
Unscrew the
BATTERY COMPARTMENT COVER (16)
and remove, exposing the
BATTERY HOLDER (17
). Insert 2 fresh
AA ALKALINE BATTERIES (18
), observing the
correct polarity as marked, and screw the cover back on to the microphone. Make
sure the cover is screwed on completely. Fresh alkaline batteries can last up to 10
hours in use, but in order to ensure optimum performance, it is recommended that
you replace the batteries after every 7-8 hours of use.
Turn on the UH-3 by sliding the audio
MUTE SWITCH (19)
to the OFF position first.
Then slide the
POWER SWITCH (21)
to the ON position. The
TX LED
indicator
(22)
will stay on. The battery indicator
LED (20)
will give a single quick flash, indicating
usable battery strength. In the case of a dead or low battery, the LED will either not
go on at all or will stay on continuously, indicating that the batteries should be
replaced with fresh ones. To preserve battery life, turn the transmitter off when not in
use.
The microphone is now ready to use. The A and/or B
DIVERSITY LED INDICATORS
(13)
on the UHF-3 receiver should now be lit, indicating a received signal from the
transmitter. When ready to speak, slide the audio
MUTE SWITCH (19)
to the ON
position. Adjust the volume of the receiver as per the Audio Output Microphone
Connection section of the above UHF-3 receiver instructions.
[Note: Observe care in selecting P.A. volume, transmitter location and speaker
placement so that acoustic feedback (howling or screeching) will be avoided.]
UH-3 HANDHELD MICROPHONE TRANSMITTER
16
17
18
19
20
22
21
6
12
11
15
13
14
15
10
9
8
6
5
7
2
1
2
4
3
1
4
