3
Warning
USING THIS SYSTEM AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE.
ALWAYS USE A VOLUME LEVEL AS LOW AS POSSIBLE.
The Occupational Safety Health Administration (OSHA) has established the following guidelines for
maximum time exposure to sound pressure levels (SPL) before hearing damage occurs:
90 dB SPL @ 8 hours
95 dB SPL @ 4 hours
100 dB SPL @ 2 hours
105 dB SPL @ 1 hour
110 dB SPL @ 1/2 hour
115 dB SPL @ 15 minutes
Avoid exposure to 120 dB SPL or greater or irreversible ear damage may result.
(Note: It is difficult to measure the SPL present at the eardrum in live sound applications. The volume
present will be affected by the level setting of your PEM-1000R, the ambient stage sound from your
other instruments and speakers, and the quality of and fit of your in-ear speakers.)
Always avoid prolonged listening at excessive sound pressure levels. Use the following guidelines to us e
this system safely:
1.
Turn up the volume to your earphones only enough to hear properly. The PEM-1000 can provide a hig h
quality monitor mix at significantly lower decibel levels than floor monitors. Whenever possible, use
the system with the limiter in the PEM-1000R receiver ON.
2.
Just as with any in-ear monitor system, The PEM-1000 works best when used exclusively by all
performers on stage (without any wedges or side monitors). The high sound pressure levels produce d
by floor monitors (especially if the band plays loud) can bleed through the in-ear monitor ear-buds and ,
in the worst cases, hinder their effectiveness. Experiment with your overall mix to get the maximum
benefit from your PEM-1000.
3.
Turn down the volume immediately if you experience any pain or hearing discomfort or ringing in the
ears after use.
4.
Have an audiologist check your hearing and ears regularly. If you experience any wax buildup in your
ears, do not use the system until an audiologist examines your ears.
5.
Wipe the earphones with an antiseptic before and after use to avoid infection. Stop using the
earphones if they cause discomfort or infection.
An equilateral triangle enclosing an exclamation point is intended to alert the users to
the presence of important operating and service instructions in the literature enclosed
with this unit.
!
4
System Features
• Available on selected frequency bands
within the UHF band for interference-
free, long-range performance (up to 8
systems can be operated simultaneously,
depending on country and frequency band)
• System consists of PEM-1000T
transmitter and one bodypack PEM-
1000R receiver, both of which offer 100
channels user select-ability. Any number of
additional receivers can also be operated
with the same transmitter if they are all
set to the same channel.
• AUTO-SCAN on receiver unit for easily
locating clear channels or manual chose
Group/Channel on transmitter
• IR (Infrared) synchronization both ways
interface between receiver and transmitter
• User-friendly menu operation with more
control options shown in LCD display
• Proprietary companding circuitry for wide
Dynamic Range and clear, natural sound
• Operating Range: Up to 500 feet typical
(depending on site conditions)
• Rugged, foam-padded traveling case
provides easy, safe transport and storage
PEM-1000T Transmitter
• Rugged, all metal half-rack that can be
rack mounted singly or side-by-side with
optional rack kits
• Front panel features stereo headphone
monitor output jack and volume control,
select button for choosing one of 100
UHF channels, Left/Right 5-segment audio
input level displays, LCD channel display,
and IR SYNC to system receivers
• Back panel provides BNC jack for the
detachable antenna, a combo 1/4” TRS
unbalanced, and balanced XLR jacks for
Left and Right Line inputs, Left and Right
1/4” TRS unbalanced loop outputs
• Externally powered by AC-DC power
adapter
PEM-1000R Receiver
• Portable bodypack receiver features a
power switch switchable with built-in
volume output level control, select button
for choosing one of 100 UHF channels,
LCD channel display, stereo/mono, Signal/
Low Battery LED indicator.
• Receiver has AUTO–SCAN for an
open channel and IR SYNC to system
transmitter
• Handy Mute Button for muting audio if
desired during use
• Operates up to 8 hours (depending on
volume) on 2x1.5V AA alkaline batteries
• Each receiver is supplied with a pair of
miniature, lightweight (yet powerful)
in-ear speakers with soft rubber mounts,
designed for “custom” form-fitted comfort
and optimum acoustic transfer and
isolation.
• Rear clip can be rotated 180˚ for attaching
receiver either vertically up or down
position.
