Quick microMGT-16 User Controls/Connections Guide
MT-16A/R Instrument Transmitter
17
18
19
20
21
22
23
26
25
24
17.
POWER SWITCH
Slide in arrow direction
to power transmitter On
18.
15dB ATTENUATION PAD
Select to
reduce the input gain by 15dB for higher level
audio input signals
19.
INPUT ¼” PLUG
Connect directly
intoguitar/bass output jack
20.
POWER &
LOW BATTERY LED
Flashes
once at power up, continuous flashing indicates
battery needs replacement
21.
IR RECEPTOR SENSOR/WINDOW
Infrared LED sensor for linking the TX to the RX
during IR frequency download
22.
BATTERY COMPARTMENT
Insert one AAA
battery, observing correct polarity
23.
INTERNAL AUDIO LEVEL ADJUST
Remove battery to access slot and adjust
internal trim-pot with small screwdriver for
optimal input level setting.
Note: this is to be
done only in rare cases as factory level setting
is already optimized for most guitars and basses
and 15dB Pad also available.Note: Set control
carefully. If trim-pot is turned past minimum
and maximum adjustment points it may need to
be backed up to achieve desired setting.
24.
ANTENNA
Permanently attached flexible
antenna
25.
BATTERY
Single AAA alkaline or NiMH
battery required for operation
26.
BATTERY COMPARTMENT COVER
Slide
to open
6
ASC
TM
IR Sync Download of Selected
Frequency of MRX-16 Receiver to
micro MT-16A/R, micro MH-16, micro
LK-16 or micro WH-16 Transmitter
(1)
ASC
™
IR SYNC INFRARED LED WINDOW
For downloading selected Channel
(Frequency) to transmitter
(21, 31, 46, 56)
MT-16A/R, MH-16, LK-16, WH-16
TRANSMITTER IR RECEPTOR SENSOR/WINDOW
Infrared LED sensor for linking the TX to the RX
during IR frequency download.
(14)
ASC
™
IR SYNC BUTTON
Press to make the IR link
download the receiver’s selected frequency to the TX.
First, turn on the system transmitter supplied (or turn
off and then on again if already on) and position its
IR window 6-12” away from the RX IR window, press
the SYNC button once and wait one second for the
RX to respond. If the IR data download is successful,
the receiver
SIGNAL LED (6)
will light indicating the
transmitter is locked in and transmitting.
