background image

Introduction

Thank you for choosing the Nady EO3 Personal In Ear Monitor

 wireless system, we know 

you will be very pleased with its performance and features. The EO3 provides high quality, 
yet cost-effective in-ear monitoring to on stage performers or behind the scenes personnel. 
The system is designed to be very easy to use and requires no installation.

The EO3 consists of one wireless transmitter (EO3-T) and one or more wireless bodypack 
receivers (EO3-R) on the same channel. The transmitter features eight factory switchable 
channels; the receivers are single channel units that operate on one of eight channels in the 
72-76 MHz band, with wide band modulation for quality audio. These frequencies are in a 
separate band that will not interfere with simultaneous use of VHF or UHF wireless systems 
on the same stage. 

The EO3 system has a wireless operating range of 300 feet, which allows it to be used with 
confidence in venues from small clubs to large theatres.

The transmitter connects to a monitor or line out from any mixing console, and broadcasts the 
audio as an FM signal to any number of pocket size Nady EO3 receivers on the same channel. 
Each receiver is equipped with an adjustable volume control, and high performance earbuds. 
Earphone enhancers—unique clear soft plastic inserts that can help secure the earbuds—are 
included. The transmitter also provides a microphone input to allow wireless cueing of the 
performers on stage.

The EO3 can provide a high quality monitor mix at significantly lower decibel levels than 
floor monitors. This is an important benefit for artists who wish to protect their hearing 
from excessive and potentially damaging sound pressure levels. 

Please read this manual completely before using your Nady EO3.

Important Note

Just as with any in-ear monitor system, the EO3 works best when used exclusively by all 
the performers on stage—without any wedges or side monitors. The high sound pressure 
levels produced by floor monitors (especially if the band plays loud) can bleed through the 
in-ear monitor earbuds, in the worst cases, thus hindering their effectiveness. Experiment 
with your mix to get the maximum benefit from your EO3.

3

Summary of Contents for EO3













Reviews: