9
Reset to default configuration
2.2.3 Decode scanning time setting
This barcode is used to set the most longest decoding time in the range of 0.50 to 25.5 second when
scanner reading barcode. First scan below barcode enter setting mode, then scan three numbers from
the appendix. Use 0 to make up three numbers if the time you want to set less than
three numbers.
For
example, you want to set 0.5 second as decode scanning time, you should scan “0””0””5” at the appendix.
If you want to set 10.5 as decode scanning time, you should scan”1””0””5” at the appendix. If you want to
c
hange or cancel one incorrect setting, scan the “
cancel setting
” in the appendix.
2.2.4 trigger mode setting
Choose one of the below mode as trigger event for scanning engine
Scan(standard)-press trigger to active red light to decode barcode, the red light will stay on and
decoding until you release the trigger or exceed the decode scanning time.
Scan(pulse)- press trigger to active red light to decode barcode, the red light will stay on until
successfully read the barcode or exceed the decode scanning time.
Continue scanning mode- Red light always on and able to decode barcode all the time.
Auto mode- Barcode scanner module start depending on ambient brightness.
Host trigger mode- Host give serial port orders, trigger scanner module start.
Scan
（
standard
）
Scan
（
pulse
）
Continuous scanning mode
Auto mode
Host trigger mode
Decode scanning time setting(default
：
3 second)