remote to select Center speaker. Then by pressing the [
<
] button set the
level to -3dB.
Press
button to scroll down to "Save & Exit
Press [ENTER] to save the new setting and at the same time exit the
Channel Levels menu. Press [SETUP] button to completely exit the Setup
menu OSD.
Confirm the relative balance of your system's loudspeakers including the
Center speaker by following the instructions in the section of the VISO
FIVE DVD Receiver Owner's Manual entitled "USING THE VISO FIVE --
AUDIO SETUP MENU".
8.
[
?
]
.
9.
10.
NAD VISO TWO
If you're using an NAD VISO TWO DVD Receiver, you must configure the
menu items “Listening Mode” and “Speaker Settings” to calibrate the
frequency response of the system. The following steps will guide you in
configuring your NAD VISO TWO receiver with respect to NAD VISO
TWENTY speakers.
Ensure that your NAD VISO TWO is unplugged when you connect the
speakers. It is also advisable to power-down or unplug all associated
components while making or breaking any signal or AC power connections.
Connect at least one of the NAD VISO TWO Monitor Outputs (Component
Video, S-Video or Composite Video Monitor Out) to a corresponding video
input of a compatible TV/Monitor.
A. With NAD VISO TWENTY speakers connected to the corresponding
speaker terminals of your NAD VISO TWO, connect the supplied AC cord
to NAD VISO TWO's AC Mains input and then plug into an AC outlet.
B. The Standby LED indicator embedded around the bezel of the POWER
button in the front panel will illuminate amber. Press the POWER button to
turn ON the NAD VISO TWO. The Standby LED indicator will turn from
amber to blue. Turn ON also your TV/Monitor and set it to the
corresponding video input setting.
You may operate the NAD VISO TWO from its front panel in combination with
10
0dB
-3dB
0dB
0dB
0dB
0dB
Front L
Center
Front R
Surr L
Surr R
Subwoofer
Do not Save & Exit
Save & Exit
Channel Levels
