ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
30
TROUBLESHOOTING
Reference
SYMPTOMS AND CORRECTION
Check the following guide for the possible cause of a problem before contacting service.
SYMPTOM
CAUSE
CORRECTION
No power
• The power cord is disconnected
• Plug the power cord into the wall outlet
securely.
The power is on, but the DVD player does
not work
• No disc is inserted.
• Insert a disc (Check that the DVD or VCD
indicator in the T562’s display is lit).
No picture
• The TV is not set to receive DVD signal
output.
• Select the appropriate video input mode
on the TV so that the picture from the
DVD player appears on the TV screen.
• The video cable is not connected securely.
• Connect the video cable into the jacks
securely.
• The connected TV power is turned off.
• Turn on the TV.
No sound
• The equipment connected with the audio
cable is not set to receive DVD signal
output.
• Select the correct input mode of the audio
receiver so you can listen to the sound
from the DVD player.
• The audio cables are not connected
securely.
• Connect the audio cable into the jacks
securely.
• The power of the equipment connected
with the audio cable is turned off.
• Turn on the equipment connected with the
audio cable.
• The Audio output settings are incorrect.
• Select either Analogue On or Analogue Off
depending on your hardware
configuration.
The playback picture is poor
• The disc is dirty.
• Clean the disc.
The DVD player does not start playback
• No disc is inserted.
• Insert a disc (Check that the DVD or VCD
indicator in the T562’s display is lit).
• An unplayable disc is inserted.
• Insert a playable disc (Check the disc type,
color system and Regional code).
• The disc is placed upside down.
• Place the disc with the playback side
down.
• The disc is not placed within the guide.
• Place the disc on the disc tray correctly
inside the guide.
• The disc is dirty.
• Clean the disc.
• A menu is on the TV screen.
• Press the SETUP button to turn off the
menu screen.
The remote control does not work
properly
• The remote control is not pointed at the
remote sensor of the DVD player.
• Point the remote control at the remote
sensor of the DVD player.
• The remote control is too far from the
DVD player.
• Operate the remote control within about
23 ft (7 m).
• There is an obstacle in the path of the
remote control and the DVD player.
• Remove the obstacle.
• The batteries in the remote control are
exhausted.
• Replace the batteries with new ones.
T562 IM english 23/7/02 9:43 am Page 30
