7
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
1 IR IN
Jack
2 DIGITAL OUT COAXIAL
Jack
3 DIGITAL OUT OPTICAL
jack
4 MIXED AUDIO OUT
(L & R) Jacks
5 5.1 CH AUDIO OUT FRONT
L & R Jacks
6 5.1 CH AUDIO OUT CENTER
and
SUBW
(Subwoofer) Jacks
7 5.1 CH AUDIO OUT SURR
(Surround Sound) L & R Jacks
8 S-VIDEO
& Composite
VIDEO OUT
Jacks (480i/576i video
resolutions)
9 COMPONENT VIDEO OUT
Jacks (480i/576i or 480p/576p, video
resolutions)
10 HDMI OUT
Jack (480p or 576p video resolutions)
11 VGA OUT
Jack (480p/576p, 720p, and 1080i video resolutions)
12 AUTO TRIGGER ON
/
OFF
Switch
13 +12V TRIGGER IN
jack
14
Power cord socket
15 POWER ON
/
OFF
16 RS 232
In/Out Jack
REAR PANEL (NORTH AMERICAN VERSION)
Identification of Controls
NOTES
Connect the optical digital cable (not supplied) firmly so that the configurations of both the cable and the connector match.
The
+12V TRIGGER IN
jack is a 3.5mm monotype miniature phone jack with the centre pin the 12V signal-sense. We recommend that you use
a good quality cable with shield when attaching the 3.5mm monotype plug so as to prevent false triggering of the amplifier due to electro-
magnetic interference from nearby electronic equipment. The
+12V-IN TRIGGER
allows you to have an external 12V signal to turn ON the NAD
M55 from standby. This 12V signal must be a continuous 12V signal in order to keep the M55 in the ON state. Once you remove the 12V signal
the M55 will return to standby. Check the specifications of the trigger input terminal the other components to ensure these are compatible with
the M55. All 12V-TRIGGER inputs and outputs on other NAD components with a 12V-TRIGGER feature are fully compatible with the NAD M55’s
12V-TRIGGER IN. Before making any connections to any 12V-TRIGGER IN make sure all components are disconnected from the AC mains. If in
doubt over the connections, installation and/or operation of the 12V-TRIGGER IN connection, consult your NAD dealer or sales representative.
Failure to observe the above may result in damage to the NAD M55 and/or any ancillary components attached to it.
The
IR IN
jack is connected to the output of an IR (infrared) repeater (Xantech or similar), or the IR output of another component to allow control
of the M55 from a remote location. Ask your dealer or custom installer for further details
M55 08.qxd 8/11/2006 9:06 AM Page 7
