12
ENGLISH
FRANÇAIS
DEUTSCH
NEDERLANDS
ESP
AÑOL
IT
ALIANO
POR
TUGUÊS
SVENSKA
REAR PANEL CONNECTIONS AND CONTROLS (FIGURE 2)
1. DISC:
Connect line-level audio Left and Right to this input from a video disc or DVD-player.
2. CD:
Connect line-level audio Left and Right to this input from a CD-player
3. TUNER:
Connect line-level audio Left and Right to this input from a tuner (radio).
4. INPUT 4-6:
Connect any audio source to these line-level audio Left and Right inputs.
Reassign new names by following the Assigning User Names procedure under the Front
Panel Controls section.
5. BALANCED:
Connect XLR audio source to these inputs. Make sure the configuration is
standard as follows; pin 1 is chassis ground (earth), pin 2 is signal live, and pin 3 is signal
return. Reassign a name to this input by following the Assigning User Names procedure
under the Front Panel Controls section.
6. MAIN IN/PRE OUT 1:
The primary link between the M3's dual mono-block preamplifier
and dual mono-block amplifier is by these jumpers. This connection supplies the full
frequency range output.
NOTE:
The
biamp
(Crossover Frequency Selection) settings do not affect this output.
PRE OUT 2:
This secondary preamplifier output follows the volume level of the
PRE OUT 1
.
Adjust the
biamp
high pass frequency settings for
PRE OUT 2
using the
biamp
(Crossover
Frequency Selection) to match the frequency response of the speakers connected to the
M3's speakers A or B terminals.
Biamp Connection:
If you choose to use the
biamp
feature of the M3 first power off the
M3, and then disconnect the M3 from the mains voltage. Disconnect the
MAIN
IN/PREOUT 1
jumper (Figure 9-1) for each channel. Connect the
PRE OUT 1
output left
and right to an active subwoofer (Figure 9-2) using high quality RCA-type patch cables.
Using a set of short high quality RCA-type patch cables, jumper from
PREOUT 2
to
MAIN
IN
both left and right channels (Figure 9-3).
If available on the subwoofer, match the subwoofer crossover settings with the biamp
crossover settings of the
PRE OUT 2
. Refer to Front Panel Controls section biamp control,
for the selection of crossover frequencies available.
About the M3 Dual Mono Integrated Amplifier:
Setup
SUBW
PRE-OUT 1 PRE-OUT 2
REC/Z2
L
R
RS-232
L
ED INPUT
+ 12V TRIGGER
OUT
INPUT 6
MAIN IN
L
R
2
R
L
SUBW
PRE-OUT 1 PRE-OUT 2
REC/Z2
L
R
RS-232
L
ED INPUT
+ 12V TRIGGER
OUT
INPUT 6
MAIN IN
L
R
R
L
3
RCA Jumpers
RCA Jumpers
PRE-OUT 1 PRE-OUT 2
REC/Z2
L
R
RS-232
L
ED INPUT
+ 12V TRIGGER
OUT
INPUT 6
MAIN IN
L
R
1
FIGURE 9
M3 10262005.qxd 1/3/2006 2:49 PM Page 12