ENGLISH
OPERATION
12
LOAD PRESET(S)
Select LOAD PRESET(S) to upload saved Preset settings/files to your
amplifier. Undertake the following steps to LOAD PRESET(S).
1
Select “Load Preset(s)” to load a saved Preset file to a desired Preset
number.
2
Select “Single Preset” if you want to load saved Preset files one at a time
or “All Presets” to load saved “All Presets” at the same time. Find and
select from the Preset file’s location/directory the Preset number(s)/files
you would like to load to your amplifier.
3
“Upload Complete” will be shown each time a Preset file or “All Presets”
file is successfully uploaded. Slope, Q, Frequency and Gain settings are
recalled, loaded and reflected in the frequency response graph upon
selection of a Preset file. Check loaded Preset(s) by selecting Preset
Editing
$
Editing
$
Preset number.
PRESET EDITING
DUPLICATE/FROM/TO
•
Select FROM drop down tab the Preset number you will copy TO
another Preset number. For example, select “Preset 1” from FROM drop
down tab and then select from TO drop down tab “Preset 2”. Afterwards,
select “DUPLICATE” to complete the copying of Preset 1 settings to
Preset 2. Current Preset 2 settings (if available) will be replaced by Preset
1 settings.
EDITING
•
Use to set Slope, Q, Frequency and Gain settings and assign/save to a
particular Preset. Refer also to SAVE PRESET(S) above.
RENAME
•
From the EDITING drop down tab, select the Preset number you
would like to rename. Upon selection of the Preset number, type in
the RENAME section the Preset name you would like to call the Preset
number and press ENTER.
RESET
•
Selecting RESET will restore current Preset number to default settings.
TEST SIGNAL
A test signal can be sampled or loaded through all the channels. This is
useful for checking audio level of each channel or comparing/balancing
audio levels among the channels.
CHANNEL
•
Select from the drop down tab the channel where test signal will be
loaded. The test signal can be assigned to Channel 1 up to Channel 8 or
select ALL for the same test signal to be loaded to all eight channels at
the same time.
TEST SIGNAL
•
Select ON for the test signal to be active for the selected channel. Turn
off test signal by selecting OFF.
