13
T 01460 68600
Located in your waste water top tank is a vacuum shut off system, this prevents suction when the waste water tank is full. It also
prevents foam created by high-foaming detergents from entering the motor. Sometimes the float vents get clogged and blocked,
clean to ensure correct operation. Regularly check and clean the air filter in the top of the assembly. Remove debris basket filter
and rinse using clean water, and refit.
IMPORTANT: If the debris basket is allowed to become clogged, vacuum performance can deteriorate.
The clean water tank filter is located to the front of the battery compartment, and should be checked at regular intervals.
Lift the filter off of the cradle, unscrew the bottom and remove, taking care not to spill any liquid on to the batteries.
Rinse using clean water and refit, refitting is reversal of removal.
Note: Any Spills should be wiped up before tank is lowered.
Machine Cleaning
Always ensure that the machine is switched off prior to any maintenance.
!
!
Free Wheel Function
operator to move the machine.
The free wheel lever can be found on the right hand side of the rear axle.
To disengage the brake, pull the lever into the down position.
Re-engage the brake by moving the lever into the up position.
Note: When the brake is disengaged the machine has no braking facility.
Care must be taken when moving the machine in free wheel mode.
ALWAYS ENSURE THAT THE MACHINE IS ON LEVEL GROUND
BEFORE DISENGAGING BRAKE ARM.
NEVER DISENGAGE THE BRAKE WHEN THE MACHINE IS ON A SLOPE / GRADIENT.
!
!
Debris basket removal.
Float vent.
Air filter.
Machine shown on it’s side.
The TGB 2120/2128 is equipped with a free wheel function that will enable the
