7
4. Proceed from the top to the bottom and cover all the surfaces to be cleaned.
While you spray the solution in the further areas, this acts chemically on the already sprayed
surfaces.
Time necessary for the chemical action
After spraying, it is necessary to leave the solution act for some minutes on the surfaces. If
the spraying step has required some minutes, the first surfaces to be sprayed are ready to
be rinsed.
The time necessary for the chemical action might vary according to the type of surface and
to the type of dirt. For a wall with average-smooth panes, it should be enough to leave the
chemical act for 2-3 minutes.
NOTE:
We advise to wait the necessary time for the solution to perform its chemical action,
in order to obtain the maximum result.
STEP B
– RINSING AND FINISHING
In order to perform t
he rinsing, it is necessary to commutate the machine from the “spray
mode” to “rinse mode”, as follows:
1.
Turn the “spray/rinse” lever in “rinse” position, on the control panel (blue drops
)
in order to spray water only, without any chemical.
2. Press the lever on the accessory. We suggest to proceed rinsing the vertical surfaces
from the top to the bottom.
Water used for rising will flow down along the walls, together with the solution and the dirt
removed. If the area cleaned has a drain hole on the hard floor, it is be possible to push the
liquid toward the drains, using the floor wiper.
STEP C
– Vacuuming the residual liquid from hard-floor
After completing the cleaning of vertical surfaces, the sanitary fixtures and all the surfaces to
be cleaned, it is possible to vacuum the residual liquid from hard floor.
