NABO KFC 6060, User Manual

Page: 32 / 56

EN - 13
4. USE OF PRODUCT
4.1 hob ControlS
The hob is controlled by pressing the
appropriate electronic button. Each button
pressed is followed by a buzzer sound.
1
3
4 5 6 7 8
2
1- Heater display
2- Activate/Deactivate heater
3- Heat setting decrease
4- Heat setting increase
5- Decimal point
6- Key lock indicator
7- Key lock
8- On/Off
Mode Descriptions
Stand-By-
Mode
S-Mode
Mains supply is applied
to the hob control and all
heater displays are off or
a residual heat display is
active.
Operating-
Mode
B-Mode
At least one heater display
shows a heat setting
between ´
0
` and ´
9
`.
Lock Mode
VR-
Mode
The hob control is locked.
Switching the Appliance On and Off
If the appliance is in Stand-By mode, it
is put in Operating mode by pressing the
On/Off button for at least 1 second. A
buzzer will sound to indicate the successful
operation.
A “ 0 ” will appear on all heater displays and
all decimal points corresponding to the
heaters will flash (1 second on, 1 second
off).
If there is no operation within 10 seconds,
all heater displays will switch off.
If the displays do switch off, the heater will
be sent into Stand-By mode.
If is pressed for more than 2 seconds
(in Operating mode), the appliance will
switch off and will enter S-Mode again. The
appliance can be switched off by pressing
at any time; even if other buttons are
pressed simultaneously.
If there is any residual heat from a heater,
this will be indicated in the corresponding
heater display.
Selecting a Heater
If a single heater is chosen with the
corresponding Activate/Deactivate Heater
Button , the decimal point of the heater
display will flash. For the selected heater,
you can set the heat level between 1 and
9 by pressing the Heat Setting Buttons
or .
The buttons must be pressed within 3
seconds of selecting a heater, otherwise the
heater selection will be erased and the heat
setting decimal point will disappear. If there
is no further operation within 10 seconds,
the heater reverts back to S-Mode.
The heat setting can always be changed by
pressing or . The available settings
are between 1 and 9.
Each button operation or each display
change is accompanied by a buzzer sound.
Set Cooking Level with and without Heat
Boost
All heaters are equipped with the heat
boost function.
If the heat boost is required, set the heat
from the current level to level 9 by pressing
the button only. Once level 9 has been
reached, press to activate the heat
boost. The display will flash “ A ” alternating
with the heat setting value “
9
” to show the
heat boost is active.
If the heat boost is active, the heater will
operate with maximum power for a period of
time dependent on the heat setting selected
before the heat boost was activated.
Once the heat boost time has ended, only
the heat setting will be indicated on the
heater display.
The heat boost can be deactivated by
pressing until the heat setting “ 0 ” is
displayed.
Switching Off Individual Heaters
A heater can be switched off in 3 different
ways:
• Simultaneous pressing of and
buttons
• Reduction of the heat setting to ´ 0 ` by
pressing the button
• Use of the timer switch-off function for
the corresponding heater.