LPA400 User Guide
IMPORTANT SAFETY INSTRUCTIONS
This product can generate lethal voltages. Observe all safety instructions.
This equipment is designed to comply with BSEN 61010-1 (Safety
requirements for electrical equipment for measurement, control, and
laboratory use)
–
observe the following precautions:
•
Ensure that the supply voltage agrees with the rating of the instrument
printed on the back panel
before
connecting the mains cord to the
supply.
•
This appliance
must
be earthed. Ensure that the instrument is
powered from a properly grounded supply outlet.
•
Use only safety connection leads approved to BSEN 61010-1.
•
The input and output connectors and the internal circuitry are isolated
from earth - do not exceed
40V peak common mode.
•
Keep all the ventilation holes on the underneath, rear, top, and sides
free from obstruction.
•
Do not operate or store under conditions where condensation may
occur or where conducting debris may enter the case.
•
There are no user serviceable parts inside the amplifier
–
do not
attempt to open the case
, refer service to the manufacturer or his
appointed agent. Potentially lethal voltages are present inside the
instrument even when no input signal is present.
•
In the event of a failure of the mains fuse, disconnect the mains cord
and replace the fuse with the same type and rating, as shown on the rear
of the amplifier.
•
Switch off the amplifier and ensure that the output current has fallen
to zero before disconnecting an inductive load from the output.
Note: Newtons4th Ltd. shall not be liable for any consequential
damages, losses, costs or expenses arising from the use or misuse
of this product however caused.