For Sales and Support, Contact Walker EMD • www.walkeremd.com • Toll-free: (800) 876-4444 • Tel: (203) 426-7700 • Fax: (203) 426-7800
(Revised 2012-10-5)
Page 99 of 169
N-Link – Status
The Status tab under the N-Link category will display the N-Link status.
If the switch is an N-Link Master or Slave, the following switch status and partner status information will be
shown. Fields with a red background designate a fault condition.
State:
Current N-Link mode of switch.
Control Port:
The port being used to convey control information. There must be a
direct link between the Master and Slave Control ports. Use of media
converters or other switches is not supported.
Partner Port:
The port being used for normal communication between the N-Link
Master and N-Link Slave switch. There must be a direct link between
the Master and Slave Partner ports. Use of media converters or other
switches is not supported. This port will be detected automatically.
Coupler Port:
The port being used to establish a redundant path for Ethernet data
transmission.
Coupler Port State:
Blocking, Forwarding.
Status:
No errors will show "OK", otherwise a description of the Faults
detected.
N-Link Partner Information
State:
Current N-Link mode of switch.
MAC:
The MAC Address of the N-Link Partner switch.
Coupler Port State:
Blocking, Forwarding.
Status:
No errors will show "OK", otherwise a description of the Faults
detected.
If switch is an N-Link Auto Configure and not a Slave, the Coupler port, if known, will be shown.
N-Link State:
Current N-Link mode of switch.
Coupler Port:
The port used to establish a redundant path for Ethernet data
transmission. This port will be detected automatically.
Below is an example of N-Link Status from a switch in defaults (N-Link Auto Configure) that is not an
N-Link Master and has not become an N-Link Slave or an N-Link Coupler:
