13
5.
PAIRING UP BLUETOOTH DEVICES
In order for the Bluetooth Kit3 PLUS system to be connected to another Bluetooth
device, the latter needs to be first paired up with the N-Com system.
The pairing up procedure is the same for all Bluetooth devices: mobile phones, MP3
Bluetooth players, satellite navigators, etc.
1.
Make sure the Bluetooth Kit3 PLUS is turned off;
2.
Press “on” and keep it pressed (for more than 4 seconds), until the LEDs
start to flash quickly and you hear a sharp beep in the headset, indicating
the “Pair-up mode”;
3.
On the Bluetooth device, turn on the search for Bluetooth devices (refer to
the instructions manual of your device for the proper pairing up procedure,
as it varies depending on the brand and model of the device);
4.
After a few seconds, the mobile phone will display the name “N-Com Bt3
v.X.XX”, followed by the manufacturer’s identification data;
5.
Select the N-Com device. If a password is requested, enter 0000 (four
zeros);
6.
Bluetooth Kit3 PLUS will confirm the pairing up by means of a tone in the
headset, and the LEDs will stop flashing;
7.
Turn off and on both the mobile phone and the Bluetooth Kit3 PLUS to store
the pairing up data.
Note: The affiliation is stored in the helmet and in the cell phone and it is not lost
when the two devices are turned off. As a result it needs to be carried out only
once.
Note: If a Bluetooth device (mobile phone or GPS) equipped with music player with
Bluetooth A2DP player has already been paired up, the pairing up DOES NOT
have to be repeated as the A2DP protocol has already been stored in the
Bluetooth Kit3 PLUS.
Once the Bluetooth device has been paired up, connection is automatic when the
system is turned on.