SS-900 Rev. A
OWNER’S MANUAL
7
MYTEK AMERICA
5. Engine will shut off in 2.5 minutes for Turbo Cool Down Mode and in between 2.5 minutes – 30
minutes for Stop and Go Mode.
6. In Stop and Go Mode, you can use optional entry method listed on section 3.1 to drive without shutting
the engine off.
7. To turn off the engine before the run time period, press and release the transmitter button #3.
3.10 Trunk Release (Option)
1. Press and hold down the transmitter button #2 for approximately two seconds.
2. Two chirp sounds and two flashing light signals verify the trunk release.
3. Trunk release solenoid unlatches the trunk automatically. Alarm is disarmed.
3.11 CH2 for Window Roll Up or Down (Option)
1. Press and hold down the transmitter button #2 until window rolls up or down.
2. Alarm stays in previous mode (Arm or Disarm).
3.12 Remote Start Reservation
To use the automatic start features such as Time Start and Low Voltage Start, you need to make a remote start
reservation before you turn off the engine. If you want to use automatic start features all the time, you need to
make a remote start reservation after each driving.
Also for manual transmission vehicles, you need to make a remote start reservation before you turn off the engine.
Without a remote start reservation, even if a start condition (Time Start and Low Voltage Start) is met or the
transmitter button #3 is pressed (Manual Transmission), the vehicle WILL NOT START!
1. When you use Turbo Cool Down Mode or Stop and Go Mode, you automatically make a remote start
reservation.
2. With the engine on, step on the brake. Then press and release the transmitter button #3.
3. One chirp sound and one parking light flash will confirm this operation.
4. Engine will stay running even after the key is removed. Exit the vehicle.
5. Close the door. Engine will shut off immediately.
6. Press and release the transmitter button #1 to arm the system. Remote Start Reservation is complete.
7. To cancel the remote start reservation, disarm the system by pressing and releasing the transmitter
button #1 then open and close the door.
SECTION 4: USER PROGRAMMABLE FEATURES
1 Chirp 1 Light Flash
Press #3
Press #1
to Arm
Step on
the brake
With engine on
Engine Stop
Remove the
Key & exit
1 Chirp or
2 Chirps
1 Light Flash or
2 Light Flashes
Press #2 or #3
for 2 seconds
Press #1
to Arm
Step on
the brake
With engine on
Remove the
Key & exit
