SS-900 Rev. A
OWNER’S MANUAL
6
MYTEK AMERICA
2. Doors will unlock and the system will disarm. Two chirps and two light flashes will verify the operation.
3. Press and release the transmitter button #1 again with antenna extended.
4. Engine stops running and the system will arm. One chirp and one light flash will verify the operation.
Optional Remote Entry Method
1. Press and release the transmitter button #1 with antenna extended.
2. Doors will unlock and the system will disarm.
3. Enter your vehicle and insert your key in the key cylinder. If you do not open the door in 20 seconds, the
system will automatically arm and lock the system.
4.
Turn your key to ON position (Normal driving position). WARNING: Do not attempt to start your
vehicle! Your vehicle has started and it is already running
.
5. Press and release the brake. The remote start functions turn off but the engine is still running due to the key
in the driving position.
6. Put in gear and drive normally.
3.7 Engine Run Verification (If remote start is installed.)
1. After remote starting your vehicle, press and release the transmitter button #3.
2. Three chirp sounds and three light flashes verify that the vehicle has started and it is running.
3.8 Cold Start Mode (If remote start is installed.)
1. Follow 3.12 Remote Start Reservation mode instruction to set the unit in reservation mode.
2. Press and hold the transmitter button #3 for more than 3 seconds with antenna extended.
3. Alarm system arms. One chirp sound and a light flash verify arming.
4. Three chirp sounds and three light flashes verify cold start mode. Release the transmitter button #3.
5. In every two hours, engine starts and runs for programmed duration (between 2.5 – 12.5 minutes) then shuts
down automatically.
6. To cancel the cold start mode, press and hold the transmitter button #3 for more than 3 seconds.
7. One chirp sound and a light flash verify the cancellation of the cold start mode.
8. Opening and closing of any doors will cancel cold start mode also.
3.9 Turbo Cool Down and Stop and Go Mode (If remote start is installed.)
Turbo Cool Down means that vehicles with turbo engines can be cooled down by using this function. Since those
vehicles with turbo engines need to have an engine cool down period of at least 2 minutes after driving, this
feature will leave the engine on after the ignition key is turned off and removed from the ignition. Engine
automatically turns off after 2.5 minutes.
Stop and Go Mode is similar to Turbo Cool Down Mode. You can use this mode to leave the climate control
(heater or air conditioner) on for short period of time when you stop by mini market to purchase drink or snack.
Engine will automatically turn off after programmed period of time (between 2.5 minutes – 30 minutes)
1. With the engine on, step on the brake. Then press and hold the transmitter button #2 for 2 seconds
for Turbo Cool Down Mode and press and hold the transmitter button #3 for Stop and Go Mode.
2. One chirp sound and one parking light flash will confirm Turbo Cool Down Mode. Two chirp sounds
and two parking light flashes will confirm Stop and Go Mode.
3. Engine will stay running even after the key is removed. Exit the vehicle.
4. Press and release the transmitter button #1 to arm the system.
Press #1
2 times
2 Chirps
2 Light Flashes
Engine Stop
Press #3
for 3 seconds
1 Chirp then
3 Chirps
1 Light Flash then
3 Light Flashes
Engine Starts
in every 2 Hours
